Fortis Enhancer Sealer – Wet Look

The concrete must be at least 28 days old before applying.

Concrete Shield Wet Look Enhancer is best applied by spraying light coats and backwiping with a micro fibre mop. Spray a light coat, backwipe and wait approx 20mins. Touch up any drier areas in the same manner until a uniform colour is achieved.

Yes, with no more than 20% xylene.

Yes. When applied to highly polished concrete any excess will need to be buffed with a slow speed polivac or similar using a red pad after 20mins. It can then be further buffed with a finer pad on a high speed burnisher after a further 12-24 hours.

Yes, however Australian standards require food grade benchtops to be sealed with a topical sealer.

Yes, Fortis Concrete Shield Densifier can be used prior to installing Wet Look to help with porosity absorption, however the densifier will need to be left for a minimum of 3 days before proceeding.

Yes, however it must be applied before the Natural Enhancer fully cures, normally within 20 hours. Always test 1st with a little Natural Enhancer to see if it penetrates. If it does then ok, if not then it has cured and will not allow the Wet Look Enhancer to penetrate. Add up to 20% xylene to the Wet Look Enhancer to help with penetration.